The Remote Control Duplicator is the easiest and least expensive way to copy any wireless remote, car key, garage door opener, and more!
This device transfers signals to duplicate your existing remote controls so you always have a duplicate remote or key available in case you lose the original.
The device can clone up to 4 remote buttons from the same or different remotes allowing you carry four remotes in one! Each corresponding letter (A, B, C, & D) can each open a different remote-controlled key.
You can open your garage door and unlock your car by using one remote control instead of carrying two keys with you.
The seamless infrared connection is secured and safe to use through data encryption.
You can copy any compatible wireless remote key and and each password is stored individually.
Portable keychain design.
Supports distance of 50-100m in open space.
Works with the following remote control IC modules (please check your original remote control before ordering),and your remotes also should be Fixed code or Learning code. AX5326-3. PT2262. PT2260. EV1527. FP527. PT2242. HT600. HT680. HT6207. HT6010. HT6012. HT6014. AX5326 4. SMC918. PT2240. HT6013. HT6013. HT12D,etc
Ships worldwide!
Note:
The frequency of the remote you need to copy should match that of the duplicate you will order.
Two-way remote control, rolling code remote control, single-chip encryption program remote control cannot be copied. Such as HCS200, HCS201, HCS300, HCS301 and so on.
Before copying the remote control, make sure that the existing code on the remote control has been cleared and check that the code is cleared successfully. Otherwise, it cannot be copied.
How to clear code:
Click and Hold A and B buttons together - Led will flash 3 times
Keep holding A button and release B button
Keep holding A button and push B button 3 times, Led will start flashing Non-stop
Now press any key on the remote control, if the LED light doesn't turn on, the delete code is a success; if you press the button and LED turns on, it means that the original code is not deleted. You need to re-clear, and only successfully clearing the code can cloning be successful. You can repeatedly clear and clone the code.
How to clone your remote:
Place both remotes as close to each other as possible.
Click and hold 1 button on your original remote and 1 button on your clone remote. Keep holding until the LED will make 2 blinks then 3 blinks then goes into Steady and you have successfully cloned. Do the same for the other buttons.
See video below on how to clear code and clone your remote.
